Ways To Use Salt And Water To Generate Electricity
Technology has always made life easy and efficient. With technology there has been so many achievement in the developing country
This is another amazing technology, it is here again.
This article provides you how salt and water can be used to generate light
Materials /equipment
Water, salt, flexible wires, light emmiting diode(led) and a container
This tools are the requirements needed to perform this operation
Steps and procedures
1 you cut the wire into two equal halves
2.you take your led which two tiny silver wire below and connect the two flexible wire onto the two silver wire of the led
3.You get your container and fill it with water and also mix it with one teaspoonful of salt.
4.You'll take your already connected flexible wires and LED and put the flexible wires into the salt water solution then you'll notice that the LED will power on to increase the rate of brightness of the LED. You can add a 9volt battery or 12v to your circuit(I.e instead of putting two flexible wire in the salt water, you one in the salt water and the other in the battery, then on the negative terminal of the battery u can connect a flexible wire and dip it inside the salt solution.
Your project is ready
Please kindly follow, like and share
God bless you
No comments:
Post a Comment